How To Setup TP Link Router Tl-Mr3220 ?
Method-1
Setup TP Link Router Tl-Mr3220:
- Please firstly select location" from the drop-down list and refer to the local ISP and 3G/4G USB modem information;
- If your country is not in the list please take "Other Location" option as reference Only.
- Please note due to firmware upgrading or various parameters changed by some 3G/4G ISPs there are some 3G/4G modems in the "Other Location" list that may NOT be compatible with our routers.
- If your 3G/4G USB modem is listed but not recognized by the router please refer to the following steps to have a try:
- Download and upgrade the router with the latest firmware which is always compatible with more 3G/4G USB modems and available at our website.
- If the problem still remains please go to 3G/4G Modem Bin File Center to check whether there is a bin file for your 3G/4G USB modem.
- If your 3G/4G USB modem finally failed to be recognized by the router.
- If you found a 3G/4G Modem is not listed but compatible with our 3G/4G router please feel free to tell us your kindly help is very valuable for other customers.
- 4G LTE Modems Compatibility apply to TL-MR3220 Version 2.0 ONLY.
Method-2
Setup TP Link Tl-Mr3220 Router:
Step 1:Connect the 4G Modem to the USB port at the back of the TP-Link TL-MR3220 Router.
- Plug the network cable to your PC and the other end of the cable into your modem.
- Turn the TP link on and wait about 1-2 minutes for it to boot up.
Step 2: Open an internet browser page and enter: 192.168.1.1 into the address bar.
Step 3: You will then be prompted for a Username and Password. Enter the following:
- Username: admin
- Password: admin
Step 4: Select Quick Start on the left hand side followed by the Next button.
Step 5: Select 3G Only followed by the Next button.
Step 6: Choose to set the Dial number and APN manually and enter the settings as shown in the figure below.
- Dial Number: *99#
- APN: splns999a1
Step 7: Choose the appropriate wireless settings for your network. WPA-PSK/WPA2-PSK is recommended.
Step 8: The router is now configured you will need to reboot the device to complete the process. To do this press the reboot button on the screen.