TP-Link Archer AX21 Router Not Working? Fix it

Fix TP-Link Archer AX21 Router Not Working:

One of the most recent additions to network equipment is the TP-Link Archer AX21 AX1800 Dual-Band WiFi 6 Router. This router, which guarantees speeds of up to 1200Mbps, could be the perfect accompaniment to your home.

However, the network settings must be set up and kept in the best condition for it to function. You can fix problems such as the TP-Link Archer AX21 Router Not Working by following the instructions in this blog.

Fixing Problems with the Archer AX21 AX1800 Dual-Band WiFi 6 Router

Internet Access is Blocked

Please switch off the main MODEM and leave it off for around five minutes. Test the internet's functionality right away after restarting it. Save the additional ethernet ports that the MODEM may have disconnected if it has more than one.

Step 1: Use an Ethernet cable to link the computer directly to the MODEM. This will fix wireless transmission difficulties as well as stop signal loss. You can get in touch with your ISP if it doesn't work.

Step 2: Go to network map settings after logging into the Tp-link router setup page. Verify that the IP address settings are correct.

Step 3: Use the Following DNS Addresses under Advanced > Network > Internet if available. Set the secondary DNS to 8.8.4.4 and the primary DNS to 8.8.8.8 now.

Step 4: If still incorrect, look at the hardware connections. You can contact your internet service provider if that fails to work.

Step 5: Go to Advanced > Network > Internet > MAC Clone on the router's online control page if you're using a cable modem. Hit the SAVE button after selecting the Clone Current Device MAC choice. The modem, as well as the router, could now both be restarted.

Low-Performance WiFi

Your TP-Link Archer AX21 AX1800 Dual-Band WiFi 6 Router's WiFi performance mostly depends on these variables. Below are a few suggestions for avoiding them and enhancing WiFi connectivity:

• Avoid placing the router in a closet-like confined area or a corner. It will hamper the spread of the signal.
• Clear the router of obstructions, heavy electrical appliances, and other electronic devices.
• To prevent signal reach from being impacted, ensure the router is kept in a central location at a specific height.
• Your TP-Link router's antenna should be vertically oriented about the surface.
• This means the antennas must be straight if you mount the router on a wall.

Admin Login ID

Click the Forget password button on the login screen if logging into your TP-Link Archer router using a TP-Link ID. Reset the same by following the instructions, then log in using the new information.

Holding the Reset located on the back for roughly 6 seconds until the Power LED blinks allows you to restore the router to its default settings. Reset the admin password after giving the routers a little opportunity to restart.